Similarly, the trigger for what happens after no motion is detected is equally limited. (And given that daylight hours change over the course of the year, this may require some tweaking in different seasons–it’d be handy if they let you base it on local sunrise/sunset times.) I’ve played around with a few different settings for these two periods, but haven’t yet found one that really accommodates my setup. So, if you want different actions triggered in the evening hours versus overnight, that’s not really possible. So you can’t have, say, daylight run from 8am to 5pm and night from 7pm to 5am. You can decide when the day starts and when the nights starts, but it automatically adjusts the other’s end point. One thing I found frustrating is that the Day/Night periods are inextricably linked. Finally, you can choose to have the lights turn off after a certain amount of time if no motion is detected. 2 And you can adjust the sensitivity of the motion detection, from low to high. You can also set a daylight threshold–if that threshold is met, the actions won’t trigger. You can tweak the motion sensor’s behavior in a few ways–for example, you can define different actions for Day and Night, which themselves are determined based on hours that you set. Because it doesn’t require a plug, you can put it basically anywhere. Choose which of your existing rooms you want to place it in, and you’re basically all set. Setup was simple: just pull the plastic battery tab out of the back of the sensor, which activates it, and then find it using the Hue app. The hardware itself is very nice it’s a small, solid-feeling little device with a wide-angle sensor and an optional mounting kit 1. The sensor arrived late last week, so I had a little time to set it up and play around with the configuration. When Philips announced earlier this year that it would be adding a $40 motion sensor to the Hue family, I was interested–but it wasn’t until I noted that it had a built-in daylight sensor that I decided I needed to test it out. But sometimes–especially in the dead of winter–it gets a bit dark and grim in my office, and it’d be nice if it could automatically turn on during the day if it wasn’t very sunny. For example, I have a floor lamp in my office that’s on a timer: it comes on in the evening and turns off when I go to bed. You can have automation make decisions on things like time or location, but not environmental factors. Note: This story has not been updated for several years.Īs good as the smart light setup in my house is, one thing I’ve found somewhat limiting is the lack of input. Philips Hue motion sensor: nice hardware, frustrating software
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |